Manual

12
INSTALLATION
WINDOW KIT INSTALLATION IN A DOUBLE-HUNG WINDOW
1. Open window or sliding door for approxi-
mately 5”
2. Cut the foam seal A and B (adhesive
type) to the proper length and attach it to
the bottom of the window. Fig. 5a.
3. Adjust the length of the window bars to
the same length and width of the opening
of the window. Cut the window piece if nec-
essary to fit the length of your window. Fig.
5b.
4. Close the window on the window slide
bars. For long term installation, you may
screw the window kit into your window
frame using the security bracket. Fig. 5c.
5. Cut the foam seal C (non-adhesive) to
the length and seal the open gap between
the top window sash and outer window
sash. Shown in Fig. 5d.
WINDOW KIT INSTALLATION IN A SLIDING WINDOW/DOOR
1. Open window or sliding door for approx-
imately 5”
2. Cut the foam seal (adhesive type) to
the proper length and attach it to the bot-
tom of the door / window. Fig. 6a.
3. Adjust the length of the window bars to
the same length and width of the opening
of the window. Cut the window piece if nec-
essary to fit the length of your window. Fig.
6b.
4. Close the door/ window on the window
slide bars. For long term installation, you
may screw the window kit into your window
frame using the security bracket. Fig. 6c.
5. Cut the foam seal C (non-adhesive) to
the length and seal the open gap between
the top window sash and outer window
sash. Show in Fig. 6d.
Foam seal A
(adhesive type)
Foam seal B (adhesive type)
Security bracket
Screws
Foam seal C
(non-adhesive type)
Foam seal A
(adhesive type)
Foam seal B
(adhesive type)
Security bracket
Screws
Foam seal C
(non-adhesive
type)
EXHAUST INSTALLATION TO THE WINDOW KIT WINDOW/DOOR
1. Make sure that window slider kit is securely installed.
2. Move the unit to the window, extend the hose, align the hose connector and snap them into the window kit.