User Manual

 Page 17

Operating
Instructions
WINDOW KIT INSTALLATION IN A DOUBLE-HUNG WINDOW
1. Open window or sliding door for approxi-mately
5”
2. Cut the foam seal A and B (adhesive type)
to the proper length and attach it to the bottom
of the window. Fig. 5a.
3. Adjust the length of the window bars to the
same length and width of the opening of the
window. Cut the window piece if nec-essary to fit
the length of your window. Fig. 5b.
4. Close the window on the window slide
bars. For long term installation, you may screw
the window kit into your window frame using
the security bracket. Fig. 5c.
5. Cut the foam seal C (non-adhesive) to the
length and seal the open gap between the top
window sash and outer window sash. Shown in
Fig. 5d.
WINDOW KIT INSTALLATION IN A SLIDING WINDOW/DOOR
1. Open window or sliding door for approx-
imately 5”
2. Cut the foam seal (adhesive type) to the
proper length and attach it to the bot-tom of the
door / window. Fig. 6a.
3. Adjust the length of the window bars to the
same length and width of the opening of the
window. Cut the window piece if nec-essary to fit
the length of your window. Fig. 6b.
4. Close the door/ window on the window slide
bars. For long term installation, you may screw
the window kit into your window frame using the
security bracket. Fig. 6c.
5. Cut the foam seal C (non-adhesive) to the
length and seal the open gap between the top
window sash and outer window sash. Show in
Fig. 6d.
Foam seal A
(adhesive type)
Foam seal B (adhesive type)
Security bracket
Screws
Foam seal C
(non-adhesive type)
Foam seal A
(adhesive type)
Foam seal B
(adhesive type)
Security bracket
Screws
Foam seal C
(non-adhesive
type)
EXHAUST INSTALLATION TO THE WINDOW KIT WINDOW/DOOR
1. Make sure that window slider kit is securely installed.
2. Move the unit to the window, extend the hose, align the hose connector and snap them into the window kit.