Installation Guide

4.0 Operation
4.1 On/Off/Standby Modes
On – AC output always on unless the battery is too low or a fault exists
Off – AC output off
Standby – The AC output will remain off until an AC load greater than 8
Watts is detected. When the AC load falls below 8 Watts, the AC output is
turned off.
4.2 LED Indications
AC Output LED STATUS LED
Figure 7 LED Identification
AC Output LED STATUS LED Operation or State
OFF OFF No power or Battery below 9.5V
OFF GREEN AC Output OFF
GREEN GREEN AC Output ON
GREEN (BLINK) GREEN AC Standby Mode
RED (BLINK) GREEN Low Voltage Disconnect (LVD) Warning
RED GREEN LVD
RED RED Inverter or System Fault *
OFF RED Inverter or System Fault *
* Refer to section 5.0 Protections for more information concerning faults
11