Manual

4 Operation

SMA Solar Technology AG

User Manual SBxx-US-1XP-40-BA-en-13 43

5. Commission the inverter (see inverter installation manual).

☑ During start-up phase of the inverter, the desired firmware is being installed. At the same

time, the status of the update is shown in the display: Update status: xxxxxxx

☑ Once the desired firmware has been installed in the inverter, the status successful is

shown in the display.

6. If the message error occurred is shown in the display, perform the firmware update again.

DANGER

Danger to life due to high voltages

• Disconnect the inverter from any voltage sources and open the enclosure lid of the

Connection Unit (see the inverter installation manual).

8. Pull the USB flash drive out of the USB port.

9. Commission the inverter (see inverter installation manual).