Installation Guide

23 TriStar MPPT-600V-TR Operator's Manual

Installation

Figure 3-3. Knock-outs, bottom view

Item

Quantity Trade Size Hole Dimension

Circuit(s)

1 2 (Concentric) 1” & 3/4” 1.36“ (34.5 mm) / 1.09” (27.8 mm) Solar (high voltage)

2 2 (Concentric) 1-1/4“ & 1“ 1.72” (43.7 mm) / 1.36“ (34.5 mm) Battery (low voltage)

3 2 (Concentric) 1-1/4" & 1" 1.72” (43.7 mm) / 1.36“ (34.5 mm) Solar (high voltage)

4 11 1/2” or M20 7/8” (22.2 mm) Solar (high voltage)

5 1 1/2” or M20 7/8” (22.2 mm) Communication

6 1 3/4” 1.09" (27.8 mm) Communication

7 4 3/4" Solar (high voltage)

8 2 1” 1.36“ (34.5 mm) Battery (low voltage)

9 3 1/2” or M20 0.88” (22.2 mm) Battery

10 2 1/2” or M20 0.88” (22.2 mm) Solar

11 2 3/4” 1.09” (27.8 mm) Solar (high voltage)

** Solar connector mounting hole diameters vary. Wieland Solar DC connectors recommended.

Table 3-1. Knock-out sizes

3.4 Controller Installation

Step 1 - Remove the Wiring Box Cover

CAUTION: Shock Hazard

Disconnect all power sources to the controller before removing the wiring box cover. Never

remove the cover when voltage exists on any of the TS-MPPT-600V-TR power connections.

PRUDENCE : Risque de décharge électrique

Déconnectez toutes les sources d’alimentation du contrôleur avant d’enlever le couvercle

du boîtier de câblage. Ne retirez jamais le couvercle en présence de tension sur une des

connexions d’alimentation du TriStar MPPT 600V.

Use a #2 Phillips screw driver to remove the four (4) screws that secure the wiring box cover as

shown in gure 3-4 below.

Figure 3-4. Remove the wiring box cover.

Step 2 - Remove the Wiring Divider

The wiring divider separates the solar high voltage wiring from the low voltage battery and

communication circuits - see Figure 3-5. The divider is secured with only one screw.

1. Use a #2 Philips screw driver to remove the screw.

2. Lift and tilt the divider towards the bottom of the unit as shown in Figure 3-5.

3. Carefully move the GFPD power wires outside of the box.

4. Lift the divider out of the wiring box and set the divider and screw aside. The divider

must be replaced in a later step.