Installation Guide

Installation Guide
TECHNICAL SPECIFICATION
FRS-01 FireRaptor Unit
Emergency Shutdown Cable 2x1mm
2
cable + Tyco SuperSeal 2-pole plug/connector (male/female)
DC Power Supply* 24VDC suitable for up to 20 FireRaptor units (40 panels)
Maximum Input Power 700W (350W per panel)
Maximum Input Voltage 150V (75V per panel)
Maximum Input Current 12A
Maximum System Voltage 1500V
Input Protection Over voltage & transient voltage supression
Maximum Output Current 12A (99.5% efciency)
Breakdown Voltage 1500VAC for 1 minute
Maximum Output Voltage 150V (75V per panel)
Output Protection Over voltage, over current & transient voltage suppression
Ambient Operating Temperature -30°C to +95°C
IP Class Protection >IP68 (designed to comply with NEMA 4X)
Casing Flame retardant Polycarbonate - UL94-V0 (f1)
Weight (without cables) 300g
Panel Cable Length 120mm
String & Signal Cable Length 1800mm
Standard Compliance EN 61000, EN 61646, EN 61215, IEC 62716 draft C (NH
3
resistant),
VDE-AR-E 2100-712, BS 7671-712
FRS-ESW1 Power Supply**
Rated Input Voltage 90-264VAC
Rated Input Current (at I
O
nom) 200mA (V
i
115VAC)/ 135mA (V
i
230VAC)
Rated Input Frequency 47-63Hz
Input Fuse T1A (250VAC)
Rated Output Voltage 24VDC
Rated Output Current 420mA
Rated Output Power 10W
Ambient Operating Temperature -30 °C to +60 °C
* FRS-ESW1/FRE-ESW1-K Rapid Shutdown Switch can be upgraded to suit larger installations. Contact IMO for more details.
** FRS-ESW2/FRS-ESW2-K includes a 250V 500mA F fuse, replace only with fuse of the specied type, current and voltage. Contact IMO for more details.
i
The Emergency Shutdown Switch is a typical “one push” large red emergency push button which requires an anti-clockwise twist to
release.
n
The FRS-ESW1 and FRS-ESW1-K includes an LED status indicator which when used with FRS-01 signies 24VDC power status (ON)
or power loss (OFF).
n
The FRS-ESW2 and FRS-ESW2-K includes an LED status indicator which when used with FRS-02 signies 24VDC power status (ON),
or power loss or trip (OFF).