Installation Guide

37TriStar Meter 2 Operator’s Manual
4.3 TriStar MeterBus Networks
The following section describes the additional meter screens
displayed on the TS-M-2, TS-RM-2, and TS-M-2-600V in
systems with two or more TriStar controllers on a MeterBus
network. Section 4.2 covers the individual controller menus.
Start-Up Displays
When the meter is plugged in and powered on, a sequence
of start-up screens will be displayed. Figure 4-8 below shows
the start-up sequence and provides a description of the infor-
mation displayed on each screen. The start-up screens are
onlydisplayedoncewhenthemeterisrstpoweredon.This
information can also be found under “System Settings” in the
System menu during normal operation.
Meter is searching the network
for devices.
Reports the number of devices
found on the network.
Meter firmware version.
Startup ends on the “System” screen
in the network device list.
Morningstar Corp
02 Devices
Searching...
©2009 v01.01.01
Morningstar Corp
SYSTEM
Figure 4-8. Start-Up Displays for Multi-TriStar Networks