Installation Guide
MORNINGSTAR CORPORATION
1.0 IMPORTANT SAFETY INSTRUCTIONS
7
6
1.0
• Mount the SunSaver-MPPT indoors. Prevent exposure
to the elements and do not allow water to enter the
controller.
• Install the SunSaver-MPPT in a location that prevents
casual contact. The SunSaver-MPPT heatsink can
become very hot during operation.
• Use insulated tools when working with batteries.
• Avoid wearing jewelry during installation.
• The battery bank must be comprised of batteries of same
type, make, and age.
• UL/IEC 62109 certified for use in negative ground or
floating systems only
• Do not smoke near the battery bank.
• Power connections must remain tight to avoid excessive
heating from a loose connection.
• Use properly sized conductors and circuit interrupters.
• The grounding terminal is located in the wiring
compartment and is identied by the symbol below:
Ground Symbol
• This charge controller is to be connected to DC circuits
only. These DC connections are identied by the symbol
below:
Informations de Sécurité
• Lisez toutes les instructions et les avertissements gu-
rant dans le manuel avant de commencer l’installation.
• Le SunSaver-MPPT ne contient aucune pièce réparable
par l’utilisateur. Ne démontez pas ni ne tentez de réparer
le contrôleur.
AVERTISSEMENT: RISQUE DE CHOC ÉLEC-
TRIQUE. NON ALIMENTATION OU AUX BORNES
D’ACCESSOIRES SONT ISOLÉS ÉLECTRIQUEMENT DE
L’ENTRÉE DE C.C ET DOIT ÊTRE ALIMENTÉS À UNE
TENSION DANGEREUSE SOLAIRE. SOUS CERTAINES
CONDITIONS DE DÉFAILLANCE, LA BATTERIE POUR-
RAIT DEVENIR TROP CHARGÉE. TEST ENTRE TOUTES
LES BORNES ET LA MASSE AVANT DE TOUCHER.
• External solaire et la batterie se déconnecte sont néces-
saires.
• Déconnectez toutes les sources d’alimentation du con-
trôleur avant d’installer ou de régler le SunSaver-MPPT.
• Le TriStar MPPT ne contient aucun fusible ou interrupt-
eur. Ne tentez pas de réparer.
• Installez des fusibles/coupe-circuits externes selon le
besoin.
Installation Safety Precautions
WARNING: This unit is not provided with a GFDI
device. This charge controller must be used with
an external GFDI device as required by Article 690 of the
National Electrical Code for the installation location.