Installation Manual

Chapter 5: Commissioning the Installation
Thischapterdescribeshowtoactivatethesystem,pairthepoweroptimizerstotheinverterandverify
theproperfunctioningofthesystem.
Step 1: Activating the System
1. VerifythattheinverterON/OFFswitchisOFF.
2.
Ifnotalreadyremoved,removetheinvertercover:Opentheinvertercover’ssixAllenscrewsand
carefullypullthecoverhorizontallybeforeloweringit.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter cover is
removed.
AVERTISSEMENT!
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le couvercle de l'onduleur
est retiré.
3.
Activatetheinverter:
a. VerifythatthecardS/NmatchestheinverterS/N.
b. Insertthecardintotheslotmarked"CARD"onthecommunicationboard.
c. TurnACON.
d.
LCDshows:Running Script...èDone!
Figure 19: Communication board and activation card
IfLCDshows:Failed:
l TurnACOFFandON(reset),andrepeattheactivationprocess.
l Usetheactivationcodethatappearsonthecertificationinverterlabeltomanuallyactivatethe
inverter.
l Iftheproblempersists,contactSolarEdgeSupport.
NOTE
Youcanusetheactivationcodethatappearsonthecertificationinverterlabeltoactivate
theinverterincaseofascripterrororamissingactivationcard.
4. Verifythattheinverterisconfiguredtothepropercountry:Presstheupordownbuttonsuntil
reachingtheIDstatusscreen:
D S P 1 / 2 : 1 . 0 2 1 0 / 1 . 0 0 3 4
C P U : 0 0 0 3 . 1 9 x x
C o u n t r y : U S A 1
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
32
Chapter 5: Commissioning the Installation