Installation Manual

6.

Hangtheinverteronthebracket:Lifttheinverterfromthesides,orholditatthetopandbottomof

theinvertertolifttheunitintoplace.DonotliftholdingtheSafetySwitchasitmaybedamaged.

Lowertheinvertersothatthenotchesontheinverterbracketsareinsertedintheholesofthewall

brackets,asshownbelow.

Figure 15: Hanging the inverter on the bracket

7.

Optionally,securetheDCSafetyUnitbrackettothewall/pole,using1-3screws:

NOTE

In case of inverter replacement with the DC Safety Unit still mounted, it is recommended to use all

3 holes.

a.

MarkthelocationofthebracketscrewfortheSafetySwitch,andoptionallythetwo

additionalbracketholes.



Figure 16: Safety Switch bracket

b. Removetheinverterfromthewall/pole.

c. DrilltheholefortheSafetySwitchbracket.

d. Hangtheinverteronthemountedbrackets.

e. FastentheSafetySwitchbracketusingastandardbolt.

Chapter 3: Installing the Inverter

Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1