Installation Manual

NOTE
Make sure the mounting surface or structure can support the weight of the inverter.
CAUTION!
SolarEdge inverters can be installed at a minimum distance of 50 m/ 164 ft from the shoreline of an
ocean or other saline environment, as long as there are no direct salt water splashes on the inverter.
AVERTISSEMENT!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m de la ligne d'eau de
l'océan ou autre environnement salin, tant qu'il n'y a pas d'éclaboussements d'eau salée directs sur
l'onduleur.
1. Determinetheinvertermountinglocation,onawall,studframingorpole.Itisrecommendedto
mounttheinverterinalocationprotectedfromdirectsunlight.
2. Toallowproperheatdissipation,maintainthefollowingminimumclearanceareasbetweenthe
inverterandotherobjects:
l Ifinstallingasingleinverter:

o
8"(20cm)fromthetopoftheinverter.

o
Atleast
4"(10cm)fromthebottomoftheinverter;ifconduitentrytotheSafetySwitchwill
befromthebottom,leavesufficientclearancefortheconduitsaswell.

o
4"(10cm)fromtherightandleftoftheinverter.
l Ifinstallingmultipleinverters:

o
Wheninstallinginvertersoneaboveoftheother,leaveatleast12"(30cm)betweeninverters.
3.
Theinverterbracketsareattachedtothedesignatedheatsinkfinsreadyforwallmounting.For
installationonapole,removethetwobracketsandattachthemtothecentralheatsinkfinone
belowtheother(donotovertightensothebracketheightcanbeadjusted).
Figure 14: Mounting the inverter brackets
4. Positionthewallmountingbracketsagainstthewall/poleandmarkthedrillingholelocations(refer
toMechanicalSpecificationsonpage70forinverterandmountingbracketdimensions).
5. Drilltheholesandmountthebrackets.Verifythatthebracketsarefirmlyattachedtothemounting
surface.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
26
Mounting the Inverter