Operating Instructions

How To Use
1. Install the toothbrush head correctly on the
toothbrush head shaft.
Align the front of the unit with the front of the
toothbrush head. Press the toothbrush head down on
the metal shaft with proper force until it cannot be
pressed.
There is a small gap (about 1 mm) between the
toothbrush head and the unit, which is a necessary
gap, not a failure.
2. Wet the bristles and apply small amount of toothpaste.
Put the bristles of the toothbrush
on the teeth at a small angle
(within 45 degrees). In order to
avoid spattering of toothpaste, put
the toothbrush head into the
mouth first, and then turn on the
power switch.
3. On / Off / Switch
On: short press to power on.
Switch: short press to switch within 5s after power on.
Off: There are three ways to turn off the toothbrush:
a. Press the on / off key again After power-on for 5s
b. After power-on, the toothbrush works for 2 minutes
and stops automatically;
c. Within 5 seconds after power-on, the toothbrush
continuously switches the working mode until it stops;
Four modes are
available
CLEAN: effectively remove dental plaque (default mode).
WHITE: deeply whiten teeth and effectively improve the
surface color of teeth.
SENSITIVE: gentle mode for sensitive areas of teeth and gums.
GUM CARE: effectively clean teeth and gently massage gums
to improve gum health.
4. Healthy brushing
Soft start
In order to adapt the teeth to high-speed vibration, the toothbrush will gradually reach
the selected speed and vibration amplitude after power-on for about 3 seconds.
Timer function to remind 30 seconds of brushing
The brushing process pauses every 30 seconds to remind the user of changing the side
for operation.
Mode memory
Each time the power switch is turned on, the toothbrush will operate in the previous
mode, for example, turn off the power switch after using the sensitive mode, and the
toothbrush will start in sensitive mode the next time the power switch is turned on.
Pressure-sensitive
When brushing too hard, the toothbrush will automatically reduce the vibration and
output intermittently to prevent excessive pressure to damage the teeth or cause
discomfort.
Example of brushing sequence
As shown in the figure, the interior of the mouth is divided into four areas: upper and
lower, left and right. First brush from the lower teeth, and slowly move the toothbrush
head; first brush the front of the teeth, then brush the rear of the teeth, and finally brush
the occlusal surface (as shown in the figure below). There will be a short pause every
30s for reminding of section change.
Front of teeth Occlusal surface Rear of teeth
It takes about 2 minutes to clean the interior of the mouth evenly and without
omission.