User's Manual
29 30
Environmental Protection Service Time:
This mark refers to the time limit (ten years). Within this period, the harmful
substances contained in the electrical and electronic products will not leak or
abrupt changes under normal use. It will not cause serious pollution, bodily
injury, or damage to property.
Tips for exhaust gas recovery:
In order to better protect the earth, when users no longer need the product or the
products service life comes to the end, please comply with the national laws and
regulations on disposal of waste electrical and electronic products and hand it over to
the local manufacturers with approved qualifications for recycling.
Names and Contents of Harmful Substances in Products
Harmful substance
DBP
Circuit
board
assembly
Plastic
(glue)
parts
Metal
parts
Power
cord
Adapter
Battery
Charging
seat
Other ac-
cessories
O
O
O
O
O
O
O
Pb
O
O
O
O
O
O
O
O
Cd
O
O
O
O
O
O
O
O
Hg
O
O
O
O
O
O
O
O
Cr6（VI）
O
O
O
O
O
O
O
O
PBB
O
O
O
O
O
O
O
O
PBDE
O
O
O
O
O
O
O
O
DIBP
O
O
O
O
O
O
O
O
DEHP
O
O
O
O
O
O
O
O
BBP
O
O
O
O
O
O
O
O O
This form is prepared according to SJ/T 11364.
O: Indicates that the content of the harmful substance in all homogeneous materials of
the component is below the limit as specified in GB/T 26572;
X: Indicates that the content of the harmful substance in at least one uniform material
of the component exceeds the limit specified in GB/T26572
Note: This product uses environmentally protection design concepts to effectively
control harmful substances. The harmful substances indicated by “X” cannot be
replaced, mainly due to technological development limitation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: