User's Manual

11 12
When the power system is started, please don't do any operation on the control handle;
When the product leaves the factory, the power system and the control handle have been networked, so the
product can be used directly, and there is no need to carry out networking operation. When you have multiple
equipment that need to be used in combination, you can use the networking function according to your needs;
The control handle can control multiple power systems, and for each networking, it cannot determine the
number of power systems that need to be networked, so the operator needs to judge the completion of the
power system networking based on the indicator, and then press the handle's start button to exit the networking
mode of the handle;
The control handle and the power system can be turned on and operated independently, so there is a possibility
that the speed level display is inconsistent after being turned on. At this time, the speed level of the control handle
shall prevail, and except starting the networking mode, the control handle can perform any operation to change
the speed level of the power system to be consistent with that of the control handle.
*
*
*
*
In the shutdown state,
press the power system
switch/networking button
for 6S to enter the
networking mode.
Items
Operation Method
RemarksPhotos
Items
Operation Method
RemarksPhotos
Power
system
networking
2
Pressing for 3S will turn on
the power system, and
continue pressing until 6S
to enter the networking
mode. After successful
networking, it will
automatically exit this
mode.
automatically shut down without
any operation in 40 minutes,
③The battery power capacity is
too low during operation
Control
handle
networking
2
In the power-on state, press
and hold the handle
networking button for 3S to
enter the networking mode.
After the power system
and the control handle
are successfully
networked, press the start
button of the control
handle to exit the
networking mode
3
.
Motor start
After the power system and the
control handle are started and
networked, press the control
handle start button to start
propeller.
Press to start, release to
stop.
To shut
down the
control
handle
① Press and hold the control
handle switch/speed-level
adjustment button for 3S in the
power-on state.
② The control handle will be
automatically shut down without
any operation in 10 minutes,
③The battery power capacity is
too low during operation
All indicators of the
control handle are off
When it has been turned on
and successfully connected
to the network, press the
control handle
switch/speed-level
adjustment button to adjust
speed. The speed will be
adjusted once you press it.
Speed level
adjustment
4
There are two speed
levels, and the speed level
is "low speed" after each
restart.
① In the power-on state,
press the power system
switch/networking toggle
button for 3S
② The system will be
Power
system
shutdown
There are two speed
levels, and the speed level
is "low speed" after each
restart.
1
2
3
1
2
3