Operation Manual
- 10 - 
.DEFROSTING   
For  the  most  efficient  operation  and  minimum  energy  consumption,  defrost  the  freezer 
when the frost on the evaporator is excessive 3 to 4 mm thick. To start defrosting, turn the 
temperature control to „MIN‟, unplug the freezer, remove the food and drawers. After the 
frost or ice has melted, discard the melted water and dry up the interior of freezer. Then the 
freezer can be restarted by a turning its thermostat to the desired setting. 
CAUTION: Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice 
from the evaporator as this will damage the evaporator. A punctured evaporator will cause 
serious problems. 
: CLEANING AND MAINTENANCE 
1. To clean the freezer, disconnect power supply and remove foods, drawers etc. Use a   
solution mixed with 2 spoons of baking soda per litre of warm water to clean the interior. 
Then wipe it clean with fresh water. 
Never use acids, chemical thinner, gasoline, benzene or the like for cleaning any part of 
the freezer. 
Never use  oiling  water and benzene  to  clean plastic parts because  they  may deform or 
damage the plastic parts. 
2. Too much foods or a too large container in the freezer will affect cold air circulation, so 
some free space must be left. It is recommended that about 70% storage volume is loaded. 
Do  not  store  volatile  and  or  explosive  materials  such  as  ethers,  gasoline,  liquefied 
petroleum gas, adhesives etc. in the freezer. Otherwise there will be a danger of explosion 
caused by electric sparks. 
. SAFETY INSTRUCTIONS   
Before plugging your freezer in check that the electric supply in your house must comply 
with the rating (voltage, frequency) of the freezer, the rating plate is usually on the back of 
the freezer. The freezer should always be plugged in its own individual electrical outlet to 
prevent overload, which could cause a possible fire hazard from overheating wires. Do not 
splash water on the freezer as this will cause electrical leakage or failure. If the power cord 
becomes  damaged,  ask on  electrician to  replace it  immediately.  The freezer must  be 
properly earthed. 
Our  corporation  is  not  responsible for  any  accident  caused  by  improper  earthing or 
improper operation. 
Any repairs and work on the appliance should only be carried out by the customer service 
department, as unauthorized work could prove highly dangerous for the user. 
Do not store explosives or sprays using combustible propellants such as butane, propane, 










