Operation Manual

- 9 -
Hinge on the left side Hinge on the right side
7. Remove the pin cap (9) from the left side of the upper frame of the door, and then
transfer it to the same location on the opposite side.
8. Put the door on the lower door hinge(6), keep the door level, then fix door on the
cabinet(10) by the upper hinge(2), then fasten the screws(3).
9. Pull the top cover (1) into the restricted block (4), then fasten the screws (8).
. OPERATION
1. Before the freezer is plugged in, check the following:
-There must not be any damage on all electrical wire.
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the freezer can be plugged in.
2. When operating for the first time
When operating is in normal condition and the freezer without any load until it auto stops at
the desired temperature, usually it takes 2 or 3 hours. Then set the thermostat to the
required setting and place foods in.
3. Temperature control
Freezer's temperature can be adjusted by turning the knob of the thermostat. The closer to
„MAX‟ position the knob is set, the lower the temperature becomes. A medium setting is the
most suitable for general operation. The position „MAX‟ is cooler than the position „MID‟.
Freezer's temperature will vary depending on the quantity of foods stored and the
frequency of the door opening, In order to maintain good cooling efficiency and save
energy, We recommend you not to store too much foods and not to open the door too
frequently.
CAUTION: When the thermostat has been turned clockwise to „MAX‟ position, do not
attempt to turn it more over. Otherwise it will be damaged.