Operation Manual

15
16
Locknuts
Adjustable foot
Loose
High
Locked
Low
To simplify the installation, there is a choice of vent outlets: one at the back, the other in the
left hand side.
Connect the hose to whichever is the more convenient by pulling the ring nut (A) from the vent
outlet at the back, aligning arrows of hose and ring nut,fastening by screwing hose to the direction
of arrow and pushing it firmly back into place. The unused vents should now be sealed with the
special snap cover (B) provided.
Advice:
If the hose is long and the room temperature low, the moisture
might condense inside the hose. This is an unavoidable natural
phenomenon. To prevent this water from Iying in the hose or
flowing back into the tumble dryer, it is advisable to drill a small
hole (dia. 3 mm) in the lowest point of the hose and to place a
small container below it.(See picture, point B).
A B
Once connected to the dryer, run the vent hose to the desired
outlet point, it contains no more than two bends. As to the outlet
itself, if you have decided on a fixed wall/window grille, a good
local builder's merchant should be able to supply you with the
necessary fittings and installation advice.
B
A