Specifications

ZERO180 Gun SystemZERO180 Gun System

Warning:

Never load a tube strip when the det cord is still

attached to the roll! Cut the necessary length of cord, the remove

the roll from the loading area!

4.2 Place the det cord through the tube strip and both end plates.

Note:

To help run the cord through the tube strip, use a non-sparking

Fish Tape or Fish Tape Leader (used by electricians and plumbers).

Insert the sh tape through tube strip and attach det cord to its end using

electrical tape. Withdraw the sh tape, pulling det cord through tube strip.

Be careful not to scrape the outer covering of the cord as the sh tape is

retracted.

4.3 Install the crimp tube support (provided in the booster transfer kit) over the end of the det cord

on designated bottom end of gun with the ared end of the crimp tube support near the end

of cord.

4.4 Make a clean, squared-off cut on the bottom end of the det cord by using Owen Super

Cutters.

4.5 Visually inspect the cut, then install the proper Bi-directional Booster over the end of the det

cord and crimp in place by using Owen Super Crimpers. The crimp support tube will not be

crimped to the cord at this time.

4.6 Slide the short booster retainer tube over the booster and det cord and thread the short

booster retainer tube into the end plate making sure that the booster stays against the internal

stop of the short booster retainer tube. Also make sure crimp support tube is pushed into the

endplate and protrudes out the opposite side of endplate. Tighten rmly by hand. No rubber

grommets will be used in this system.