Specifications

MODELS 9301, 9302, 9303E, 9600, 9601 ONLY 9302E,
BENT BLADE
Tilt the mower up on the knurfing bar and place a
straightedge (yardstick) across the bottom of the
pan.
Rotate the blade until one end is aligned with
the straightedge and measure the gap between the
blade and the straightedge.
Rotate the blade until
the other end
is under the same point of the
straightedge and measure
this gap. If the gaps are
not within
1/4” of each other, the blade, blade
spindle, blade adaptor or deck may
be damaged or
distorted. Remove blade and place on flat surface.
If blade tips are not within 1/4” replace.
SAFETY WARNING
WHEN INSTALLING THE BLADE
STALLED IN THE CORRECT SE-
QUENCE IN WHICH THEY WERE
TIGHTEN BLADE NUT SECURELY
ING
LOOSE.
MAKE SURE ALL PARTS ARE :IN-
REMOVED. SEE FIGURE
2-46.
TO PREVENT BLADE FROM COM-