Specifications

MODELS 9301, 9302, 9302E, 9303E, ‘9600, 9601 ONLY
FINAL DRIVE DISASSEMBLY
DIFFERENTIAL REMOVAL
Disconnect spark plug lead; remove battery (elec-
tric start models only).
SAFETY WARNING
WHEN STANDING MOWER ON END,
ALWAYS ANCHOR IT
TO PREVENT
FROM TIPPING OR FALLING. ALSO
TION AND DISCONNECT SPARK
PLUG LEAD.
PLACE THROTTLE IN
“STOP” POSI-
Stand mower on tilt (knurfing) bar.
Remove rear belt.
!
Remove rods from carrier bracket and disc
compression springs. Lower bracket to
floor.
Remove chain, rear wheels and axle bear-
ings.
Place blade control lever in “on” position
and slide differential out.
NOTE
Be careful not to mar the drive
disc
with the differential sprocket
teeth when removing the differential.
Reassemble
in reverse order of disassem-
bly. After reassembly place blade control
lever
in off position.
DIFFERENTIAL DISASSEMBLY
Remove differential. (See above.)
Remove four bolts holding differential and
sprocket together. Differential halves can
then be separated. Inspect parts, etc., (Fig-
ure
2-39.
When reassembling, pack differential with 3 ounces
of Lawn-Boy “A” grease/
11-48 SERVICE BULLETIN REFERENCES
REVISED 1977