User guide

45
Inlet Strainer Cleaning
Should the inlet strainer units require cleaning or renewal then follow the procedure
below:
Important! Use only silicone based lubricants when reassembling.
1. Follow the procedure detailed in “Cartridge Renewal”: instructions 1. to 5. to
dismantle the shower control.
2. Pull the inlet strainer units from the valve body.
3. Clean the complete strainer unit under running water. Check for damage and renew
the whole unit if necessary.
4. Refit the strainer units. The strainer units can only be fitted one way (refer to
Figure 4).
Important! Ensure the 'O' seals on the inlet strainers are well-lubricated before
refitting.
5. Follow the procedure detailed in “Cartridge Renewal”: instructions 7. to 14. to
reassemble the shower control.
Cover
Cover Retaining
Screws
Plastic Pins
Cover 'O' Seal
'O' Seal
Figure 4
Cartridge
Inlet Strainer Unit