User guide

24
14. Plaster and tile up to the tapered sides
of the plastic building-in shroud and,
when set remove the shroud. The two
M5 shroud retaining screws should be
screwed temporarily into the base of the
shower control for use later.
15. Push the control knob cap on to the
shower control knob.
16. Fit the foam seal over the reverse side
of the circular mounting bracket.
17. Fix the circular mounting bracket to the
shower control body using the two M5 x
50 mm screws used to retain the plastic
building-in shroud.
Note! The bracket has been designed
with semicircular knock outs which may
need to be relieved to accommodate the
supply pipework under minimum
building-in depth conditions.
18. Push the concealing plate firmly over
the circular mounting bracket until it
locates on the four clips.
19. This completes the installation of the
Mira CombiForce 415B for installation
into “Solid, Dry-lined, Stud Partition
or Dry Partition Wall Structures”.
Foam
Seal
Circular
Mounting
Bracket
M5 x 50 mm
Screw
Concealing
Plate
Control
Knob Cap
Control
Knob