User guide

23
11. Connect the incoming hot and cold water
supply pipes :
11.1 Slide the compression nut, then
the olive, over the pipe end. If
necessary, sparingly smear
liquid jointing on the pipe end
and the outside of the olive.
11.2 Insert the pipe end into the
opening of the inlet connector
then slide the olive and
compression nut into place.
11.3 Finally, carefully tighten,
clockwise, the compression
nuts.
12. Connect the outlet pipe :
12.1 Place the ‘O’ seal on to the
nipple, as shown. Locate the
hexagon towards the shower
control outlet port. Screw the
nipple, clockwise, into the outlet
port using a 12 mm A/F
hexagon wrench (not supplied).
12.2 Slide the compression nut, then
the olive, over the pipe end. If
necessary, sparingly, smear
liquid jointing on the pipe end.
12.3 Insert pipe end into the opening
of the outlet nipple then slide
the olive and compression nut
into place.
12.4 Finally, carefully tighten,
clockwise, the components.
Turn on the water supplies and check
the pipework for any leaks!
13. Refit the plastic building-in shroud over
the shower control and secure with the
two M5 x 50 mm shroud retaining screws,
removed in instruction 2.
'O' Seal
Outlet
Nipple