User guide

20
Mira CombiForce 415B Built-in Shower Control
The building-in depth for the integral wall
mounting bracket assembly is 58 mm. The
building-in depth for the shower control (to
the finished wall surface) is between 64 and
81 mm. The building-in depth calculation
must include the final thickness of plaster
and tiles. This dimension determines how
much of the control knob will be visible
through the concealing plate when the
installation is completed.
Outlet Port
Hot
Inlet
Port
Shower
Control
Building-in
Shroud
Raised
Portion
The built-in shower control incorporates an
integral wall mounting bracket assembly
which can be used to install the shower into
a solid, dry-lined, stud partition or dry
partition wall structure, shower cubicle or
laminated panel. Installers may wish to
consider other options such as fabricating
rear supports using wooden noggins,
however, these methods of fixing are beyond
the scope of this guide.
A building-in shroud is supplied, which protects the shower control during plastering
and provides a reference for the building-in depth when chasing out the wall surface.
The built-in shower control has
1
/
2
" BSP male inlets and is supplied with 15 mm
compression fittings. The outlet has a
1
/
2
" BSP tapping and supplied with a nipple
terminating in a
1
/
2
" BSP male or 15 mm compression fitting.
230
134
110
146
214
53
43
67
92 A/F
12
38
Wall
Mounting
Bracket
Backplate
Ø101