User guide

14
1. Before you decide on the final position
of your shower control, please bear in
mind the following:
- Decide on a suitable position for
the shower control. The position
of the shower control and the
shower fittings must provide a
minimum gap of 25 mm between
the spill-over level of the shower
tray/bath and the handset. This
is to prevent backsiphonage.
- Determine whether the hot or
cold water services will be
connected to the shower control
from the bottom (rising) or from
the top (falling).
7
Installation
Section
Falling Supplies
Rising Supplies
25 mm
Minimum
Spill-over Level
Hose Retaining
Ring
Mira CombiForce 415 Surface Mounted Shower Control
Rising or Falling Inlet Supplies
Note! The Mira CombiForce 415 is supplied with inlet connections hot left, cold right
and bottom outlet as standard. For installations with reversed hot and cold supplies
complete the installation and refer to the section Installation: "Reversed Inlet
Supplies".