Manual

Features
Cycle Signal Control (some models)
When the Cycle Signal Control is ON, a signal will sound at the end of each
cycle and during the Press Saver setting (some models). The volume is
adjustable on some models.
Drum Light (some models)
A drum light will come on whenever the door is opened to illuminate the dryer
drum during loading and unloading. Closing the door turns off the light.
Use the drying rack to dry items which
should not be tumbled.
Drying Rack (some models)
Use the drying rack to dry items which should not be tumble dried.
1. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Place the front bar under the lip
of the lint screen opening.
3. Place items to be dried on top of rack. Weight should not exceed 10 Ibs.
Leave space between items, but do not let items hang over the sides or
through the grids. Do not tumble other items when using the drying rack.
4. Select a timed dry setting best suited for items being dried. Use only the
Air Fluff (no heat) temperature setting for items containing plastic, foam
rubber, rubber-like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint
screen is not in place, tumbling items could enter the exhaust system and
cause damage to the dryer.
Common Drying
Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For
satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM
Greasy, oily
stains
POSSIBLE CAUSES
.Fabdc softener sheet.
SOLUTIONS
.Rub fabric softener stains with bar
soap.
Rinse and rewash.
PREVENTIVE MEASURES
• Add a few bath towels to srnall loads for ploper
tumbling.
• Some "silk-like" fabrics should be air dried.
*Use proper drying temperature.
• Place fabric softener sheet on top of load before
starting the dryer.
Lint .Overloading.
* Overdrylng causes static
electricity.
.Lint screen not dean
when cycle began.
*Lint is attached to "pills."
• Reduce load size and rewash using *Do not overload dryer.
liquid fabric softener in the final rinse. .Use fabric softener in washer or dryer to reduce
.Or, add a fablic softener sheet and static electridty.
tumble without heat. *Remove items when they are slightly damp to
.Use lint brush or roller to remove lint. avoid overdrying.
• Check that lint screen is dean and in place.
r,,,,uDm_n_ .Pilling is normal with .Use a lint brush or shavel to remove .Use fabric softener to lubricate fibers.
(Fibers break off, synthetic and permanent pills. .When ironing, use spray starch or fabric finish on
ball up and cling p_ess fabrics. This is due to collars and cuffs.
._,,fahrlc._ abrasion from normal .Turn items inside out to reduce abrasion.
to
wear.
Shrinking *Overdrying. .Irreversible condition. .Follow fabric care label directions.
• If shrinking is a concern, check load often.
.Remove items while slightly damp.
.Block knits into shape.
*Lay flat to complete drying.
Wrinkling .Overloading.
*Leaving items in dryer
after cycle ends.
.Reduce load size and tumble at
medium or low heat for 5-10 minutes.
.Remove items immediately. Hang or
fold.
10
.Do not overload dwer.
• Remove items as soon as cycle ends.