® CoinMaster Pro ™ White’s Electronics, Inc.
Assembly 1) Remove all parts from shipping carton (see cover). 2) Use nonmetallic washers (between round search coil and clevis fiber rod) and fiber bolt and thumbnut to secure search coil to fiber rod. 3) Insert fiber rod into curved rod, line up buttons into one of adjustment holes. 4) Unravel search coil cable and wind around rods (first revolution over top of rod). Plug search coil cable into control box, screw “finger-tight” to secure.
Display Indications •Typical Metal Target Categories •Current Metal Indication •Disc/Rejection •Low Battery Indication •Current Metal’s Depth •P/P (Pinpoint) All Metal Mode •Current Sensitivity Setting •Tone Identification Activated Controls 1) ON/OFF turns the Power ON and OFF. Low Battery indication is automatically shown on the display. Remove batteries for storage beyond two weeks. 2) SENS (sensitivity) adjust the responsiveness to metals, ground, and external electrical interference.
® Warranty If within two years (24 months) from the original date of purchase, your White’s detector fails due to defects in either material or workmanship, White’s will repair or replace at its option, all necessary parts without charge for parts or labor. Simply return the complete detector to the Dealer where you purchased it, or to your nearest Authorized Service Center. The unit must be accompanied by a detailed explanation of the symptoms of the failure.
