Install Instructions

PART NO. 37-5379F
Replaces 37-5379E
0616
F92-0659 and F92-0836
Regulated Natural to L.P. Gas
Conversion Kit
INSTALLATION INSTRUCTIONS
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL
INJURY AND/OR PROPERTY DAMAGE.
Installer: Save these instructions for future use!
This conversion kit shall be installed by a qualified
service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements
of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a fire, explo-
sion, or production of carbon monoxide may result,
causing property damage, personal injury, or loss of
life. The qualified service agency performing the work
assumes the responsibility for the proper conversion
of this appliance with this kit.
APPLICATION
This regulated Natural Gas to regulated L.P. Gas conversion kit
allows the 36C, 36D, 36E, 36F, 36G, 36H and 36J Series gas
valves to be used on L.P. gas applications. This conversion kit
is for use on all single stage, fast and slow open models and
36G, 36H and 36J two stage models.
TO CONVERT FROM NATURAL TO L.P. GAS
1. Remove regulator cover screw.
2. Remove regulator adjustment screw (beneath the cover
screw).
3. Remove Natural Gas regulator spring from regulator sleeve.
4. Insert the L.P. regulator spring (provided in the conversion kit)
into the regulator sleeve.
5. Replace the regulator adjustment screw. Then adjust the outlet
pressure to the appliance manufacturer’s specified outlet
pressure.
6. Replace the regulator cover screw.
7. Attach the WARNING label (provided in the kit) to the gas valve
where it can be readily seen. Also attach the small round L.P.
label to the top of the regulator cover screw.
8. If present pilot burner is to be used, the pilot orifice must be
replaced.
Conversion back to Natural Gas use may be made at a later
date by retaining the Natural Gas spring (removed in step 3,
above) and following the same procedures (except for burner
pressure given in step 5).
Figure 1. 36C and 36D
Models
Regulator
Cover Screw
Regulator
Spring
VENT
Plastic Regulator
Adjustment
Screw
Regulator
Sleeve
Regulator
Cover
Screw
Regulator
Spring
Plastic
Regulator
Adjustment
Screw
Figure 2. 36E, 36F,
36G and 36J
Single Stage
Models
Regulator
Sleeve
WARNING
!
VALVE CONVERTED FOR USE ON L.P.
GAS. IMPROPER OPERATION COULD
RESULT IN DEATH OR SERIOUS
INJURY.
WARNING
!
SOUPAPE CONVERTIE POUR USAGE
SUR GAZ DE PÉTROLE LIQUÉFIÉ.
UN FONCTIONNEMENT INAPPROPRIÉ
PEUT PROVOQUER LA MORT OU DES
BLESSURES GRAVES.
MISE EN GARDE
!
Figure 5. Contents of kit
WARNING Label
L.P. Regulator
Spring
L.P. Label
LP
Regulator
Cover Screw
Regulator Spring
Plastic Regulator
Adjustment Screw
If low outlet
pressure greater
than 5" W.C. is
required, use an
additional kit to
convert low pressure.
Figure 3. 36G and 36J
2-Stage models
Regulator
Cover Screw
Regulator Spring
Plastic Regulator
Adjustment Screw
If low outlet pressure greater
than 5" W.C. is required, use
an additional kit to
convert low pressure.
Figure 4. 36H Single Stage
and 2-Stage models
White-Rodgers is a division
of Emerson Electric Co.
www.white-rodgers.com