Owner`s manual

30786-7-0415Page 40
 



tube 2 1/2” (64mm) beyond the vinyl siding kit or wall. See
Figure 57.

tape gasket needs to be used.
9. Mark or wrap tape completely around the tubes at the marked
points to help in making a true cut. Do not crimp or enlarge
tubes.
10. From outside: Push the 6 5/8” (168mm) diameter inlet tube/
mounting plate onto end of rigid venting system to correct posi-
tion. Fasten the outside mounting plate to the vinyl siding kit or
wall with (4) 10 x 1 1/2” screws. (Ensure upward slope).
11. From inside: Attach the inlet tube to the collar on the back of

screws.
-
tions and diagram (Figure 58).

-
ing system). Hold the tube by the seam and push in using a
perpendicular “rocking” motion. This ensures the seam on the
tube stay intact.
14. Fasten vent cap end using (3) 10 x 1/2” screws to mounting
plate.
Sealing 4” (102mm) Diameter Flue Outlet Tube
7. Remove outside mounting plate with tube attached from wall.
Mark and cut the extra length of the 6 5/8” (168mm) diameter
tube from the opposite end. Do not crimp or enlarge tube.
OUTSIDE WALL
MEASURE
VINYL SIDING KIT DV822
OUTSIDE MOUNTING
PLATE
EXT.WALL
SURFACE OR
VINYL SIDING KIT
FLUE
PIPE
CUT
2½”
BEYOND EXTERNAL
WALL SURFACE OR
VINYL SIDING KIT
Figure 56
Figure 57
1
”
VENT CAP END
APPLY SEALANT
ON THE INSIDE
DO NOT PLACE
OVERLAPPED
SECTION OVER
THE SEAM IN THE TUBE
Figure 58
Note:

venting system.
DVVK-4RE VENT KIT INSTALLATION INSTRUCTIONS (continued)