Owner`s manual
30786-7-0415 Page 15
Fireplace Framing
Framing should be constructed to accommodate wall covering and
of 2 x 4 lumber or heavier. The framing headers may rest on the top
standoff spacers. Refer to Figure 12 for framing dimensions.
Note: On Peninsula models, a maximum weight of 230 lbs. must
not be exceeded when construction materials are supported by the
top standoff spacers.
FIREPLACE INSTALLATION INSTRUCTIONS
Fireplace Framing Dimensions (in inches)
"A" "B" "C"*
Model Framing
Height
Framing
Width
Framing
Depth
DVP36SP 41 1/2" 40" 23"*
DVP36PP 41 1/2" 39"** 23"*
Attention: Add height of base to "A" Dimension when elevat-
Framing dimension A includes a three inch clearance for
front faces.
** Peninsula model framing width assumes use of 1/2" wall
A
B
C
A
B
C
Framing - Peninsula
Framing - See-Through
Figure 12
determine where the unit is to be installed and whether optional
accessories are desired. Gas supply piping should also be planned
at this time. A gas shutoff must be installed in this line.
2. A raised platform of combustible or non-combustible material.
perimeter edges on the bottom of the unit.
(Example: Four (4) concrete masonry blocks.)
installed on a metal or wood panel extending the full width
and depth of the unit.
At this point, you should have decided what components to include
has not been done, stop and consult your dealer for assistance
with this planning.
Accessory kits such as the FBB5 Blower kit, Trim kits, Mantels, plus
other Decorative Frame, Hood, and Door accessory kits may be
Refer to the instructions provided with each of the optional accessory
kits for proper installation and operation.
PLANNING INSTALLATION










