Technical data

ALWAYS CLEAN THE FILTER AFTER EACH USE.
Failure to do so could cause the safety cut-out to operate.
Your dryer will only function well if the machine is clean.
- The filter collects fluff which accumulates during drying and it must therefore be removed and
cleaned at the end of each programme.
- Remove any threads or fluff by hand or with a soft brush.
- Wash the filter occasionally in detergent solution using a soft brush to remove small particles.
- If your filter becomes damaged, replace it to ensure no damage is caused to the dryer.
ANY PROBLEMS
If the clothes are not dry after normal drying time:
– Check that you used the correct heat setting.
– Check that you have not set the timer within a cool down period.
– Check that the lint filter has been cleaned. A blocked filter will restrict the airflow.
– Check that your dryer is heating – the door window should feel warm to touch after the first 10-
15 minutes of its programme.
Failure to heat may indicate the safety cut-out has operated. To reset, simply press the red button at
the rear of the machine. If it has operated then a sharp “click” will be heard.
This cut-out only operates if the airflow is severely restricted so make sure the filter is clean, the air
inlets and outlets at the side and back are not blocked, and that all other restrictions are removed
before restarting.
If the cut-out continues to operate after checking the above points, you should contact your service
agent.
Check that the machine has the correct weight load in the drum before starting the appliance.
If your machine does not work check the following before calling a service engineer:-
- Check that there is a supply of electricity.
- Check that the door has been properly closed and the machine is switched on.