Technical data

Dry your hands.
Check the timer is in the’0’ position.
Switch on the machine at the socket.
Select correct heat position (See programme chart on facia panel).
The standard cotton programme is suitable to dry normal wet cotton laundry. It is the most efficient
programme in terms of energy consumption for drying wet cotton laundry.
Your appliance is a reversing, small door opening, a full load will typically take 115 minutes and will
use approximately 3.92kWh of electricity. A half load will typically take 65 minutes and will use
approximately 2.08 kWh of electricity.
Set the timer to the correct position (See programme chart on facia panel).
For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for
cotton and set the timer to the recommended drying time for cotton dry as specified on the control
panel.
Press the start button.
The drum will now begin to rotate and stop when the timer automatically reaches the ‘0’ position.
Should the clothes become dry before the cycle has finished the thermostat will automatically switch
off the heater and prevent overdrying and save energy although the drum will still rotate.
When drying large items such as sheets, we suggest you stop the dryer to redistribute the load.
To stop the machine during the middle of a programme simply open the door: the drum will stop
rotating automatically. To re start, close the door and press the start button.
To lengthen or shorten the programme, turn the timer knob.
The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items
are left at a temperature that ensures that the items will not be damaged.
After removing the dried clothes clean the filter as follows:
Pull the filter upwards.
Remove any thread or fluff by hand or with a soft brush.
Slide the filter back.
Wash the filter occasionally in detergent solution and with a soft brush remove small particles.
Switch off the electricity supply.
CARE LABELS YOU
MAY FIND ON
YOUR FABRICS