Technical data

If the through the wall vent is to be positioned other than behind the dryer, the vent hose should be
positioned at floor level and through adjacent side panel to a relevant position. The plinth must be cut-
out to accommodate the air vent grill at the bottom front of the tumble dryer.
IMPORTANT
The air vent at the front of the appliance must never be covered or blocked in any way as this will
cause the dryer to overheat.
This appliance must not be installed behind a lockable door, a sliding door or a door with hinges on
the opposite side to that of the tumble dryer.
The dryer should not be placed directly next to ovens or cookers, as the performance of the dryer may
be affected.
ELECTRICAL CONNECTIONS: We strongly recommend that any electrical work is carried out by a
qualified person complying with the IEE 17
th
addition of the electrical regulations.
IMPORTANT
Please remember that the tumble dryer must be capable of being switched off, (disconnected from the
supply), when fitted in position
THE FILTER
The filter is found, as seen from the diagram, by opening the door and must always be in position
when drying items in the appliance. To allow the dryer to operate efficiently it should be cleaned after
each drying cycle. Do not be alarmed by the amount of fluff deposited on the mesh. It is not due to
excessive wear caused by the dryer but more an indication of it’s efficient operation. All fabric loses
fluff when drying but it goes unnoticed into the air. In a tumble dryer it simply collects in the filter.