User's Manual

INSTALLATION
Sensor Location
The factory has already set up the codes for the 4 sensors
which are provided and matched with
the monitor, and each sensor is
marked with the corresponding tire
position [LF, RF, LR, RR, SP (spare
tire)]. Install each sensor in the correct
tire position as per the diagram.
Sensor Battery Installation
1. Unscrew the sensor cap.
2. Insert battery into sensor ensuring that the
positive “+” is facing up.
3. Replace the sensor cap.
Repeat for the remaining sensors.
Sensor Installation
1. Unscrew the tire valve cap and mount the tire sensor in its
place.
2. Save the tire valve cap in the vehicle’s storage
compartment. Important: Only hand tighten the sensor
cap to prevent possible damage to the sensor.
CAUTION:
After proper sensor installation, it is
highly recommended to check for any
air leakage. Test by spraying soapy
water on the valve stem and look for
bubbles. No bubbles, no leaks.
Retighten if bubbles appear.
5
tirescout.qxp 3/12/2012 10:34 AM Page 6