User's Manual

Replacing the Transmitter Battery - continued

4. Replace a new CR1632 battery cell, ensure the positive “+”

is facing upwards.

5. Check that the water-proof rubber seal is in its proper

position. Screw the sensor cap back on.

NOTE: If the water-proof seal is missing or damaged replace

with a new seal that was provided with the unit. Failure to

install this seal will damage the transmitter.

CAUTION:

After the sensor re-installation, it is highly recommended to

check for any air leakage. Test by spraying soapy water on the

valve stem and look for bubbles. No bubbles, no leaks.

OPERATION

tirescout.qxp 3/12/2012 10:34 AM Page 16