User's Manual

60
UPDATING EZ Scan SOFTWARE
Using EZ Scan Software to update
the WS1095 / WS1098
1. Turn off the Scanner. Disconnect the USB cable
from the scanner, but keep the USB cable
connected to your computer.
2. Connect the USB cable to the Scanner.
3. Select Check for CPU Firmware Update in the
update menu.
4. Click Check for Updates on the update screen.
5. If there are available updates, click Update My
Scanner .
6. Please be patient, this can take several minutes.
When complete, click Done .
DSP Firmware Updates
1. Turn off the scanner.
2. Connect the scanner to your computer using the
USB cable supplied. The computer should
recognize the scanner’s SD card as a new drive. If
an autorun screen appears, close it.
3. Select Check for DSP Firmware Updates in the
update menu.
4. Click Check for Updates .
5. If there are available updates, click Update My
Scanner.
6. Please be patient, this can take several minutes.
When complete, click Done .
DRAFT