User's Manual

114
Detailed Menu Reference
115
STLK
Parameters
Options Description
Backlight On, Off or Flash Controls whether the backlight should be on,
off or flashing while the object is active.
Alarm None, Chirp,
Hi-Lo, Alert,
Ring, 2-Chirp,
Fast Hi-Lo,
DTMF#
Sets the Audible Alarm for the STLK object.
When an Audible Alarm is selected, the select-
ed alarm will play anytime the scanner stops
for activity on the STLK object while scanning.
Fav
Yes or No When On, the STLK object is a member of the
Favorites Scan List.
EXPERT BELOW
Atten On or Off When on, applies 20 dB of attenuation to all
hits received on the STLK search. Useful in
areas where interference from nearby strong
signals is present.
Delay On or Off Controls whether a Delay is used to wait for
reply traffic after a transmission on the STLK
search.
Delay Time 1-250 x 100ms Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is
On, e.g., 20=2 seconds.
Zeromatic On or Off When on, enhances the scanner’s ability to lock
on to the actual center frequency of a search
hit instead of an adjacent frequency.
Special On or Off STLK works by quickly sweeping the RF spec-
trum in 1 MHz increments to find nearby strong
signals. If the 1 MHz sweep indicates that activ-
ity is present in the 1 MHz range, STLK sweeps
that range to find the source.
Search Dir Up or Down Sets search direction used when STLK object
is active.
Hit Count Numeric value Increments each time a transmission is
received on the STLK object. Global “Hit
Counts” must be set to ON. Press the Dflt
softkey to reset to 0.