User's Manual

19
Using the Priority Channel
The priority feature sets the scanner to check one
specic channel every two seconds while scanning. You
can only program one frequency into the priority channel.
1.
Press PGM.
2.
Press PRI/ALERT. PCH and
000.0000 (or the previously
stored frequency) appear.
3.
Enter the frequency you
want stored in the priority
channel, then press ENT.
4.
To turn on the priority
feature, press
PRI/ALERT during scanning
or searching. PRI appears.
The scanner checks the priority channel every two
seconds and stays on the channel if there is activity.
To turn o the priority feature, press PRI/ALERT.
PRI disappears.
Signal Stalker II
Signal Stalker II allows you to sweep a range of
frequencies to detect, monitor and store frequencies for
nearby radio transmissions.
The Signal Stalker II feature is more sensitive than
portable frequency counters and detects transmissions
at greater distances.
The Signal Stalker II can be set to watch for activity on
all bands, or on Police/Fire, Aircraft, or Ham frequencies
exclusively.
When the scanner is in manual, scan or tune mode, press
to watch for activity on all bands.
To watch for activity on Police/Fire, Aircraft, or Ham
frequencies exclusively, press the button for the desired
service bank and then press
.
NOTE: Priority mode is not available while using the
Signal Stalker II.
1
4
3
2