User's Manual

18
Scanning and Monitoring
Press SCAN/MAN until SCAN appears to continuously
scan through all channels with stored frequencies. If the
scanner nds an active frequency, it pauses until the
transmission ends.
Press  or  to change the scanning direction.
To monitor a channel, press SCAN/MAN so that MAN
appears.
The scanner does not scan channels in banks that are
turned o. To turn a channel-storage bank on or o,
press the bank’s number key (1–0, using 0 for bank 10)
during scanning. The channel-storage banks that are ON
have a bar underneath them.
• You cannot turn o all banks; there must be at least one
active bank.
• You can manually select any channel in a bank, even if
the bank is turned o.
Setting Delay
To avoid missing a reply in conversations, a two-second
delay is automatically set for each channel. The scanner
stops for two seconds after a transmission ends before
it resumes scanning or searching. DLY appears on the
display when the delay function is active.
To turn delay on:
• If the scanner is scanning and stops on an active
channel, quickly press •/DELAY before it resumes.
• If the desired channel is not selected, manually select
the channel, then press •/DELAY.
• If the scanner is searching, press •/DELAY. DLY
appears and the scanner adds a two-second delay to
every transmission it stops on in that bank.
To turn delay o:
Press •/DELAY while the scanner is monitoring a channel
or frequency. DLY disappears.