User's Guide

Unit is assembled at the factory for mounting along top

edge of License plate. See Disclaimer section of this user

guide before mounting to vehicle.

NOTE: If you will be attaching the unit to the bottom of your

license plate, please follow the steps below:

1. Locate then remove the four screws holding the bracket

onto the camera.

2. Flip bracket, use the four screws to attach to back of

camera. The end result should be the USB door on the

right hand side as you face the camera when mounted to

the bottom of your license plate.

3. Secure the camera assembly to license plate using the short

machine screws and machine nuts. Cushions have been

included to avoid scratching your vehicles paint.

NOTE: Be sure to adjust the height of the camera assembly

to not impair readibility of the state, registration decal, stamp,

or other device indicating the month and year in which the

vehicles registration expires when securing to your license

plate.

ScrewsScrews

ASSEMBLY / INSTALLATION

Cushions

Machine Screws