User's Guide

TEST THE CAMERA / PAIRING

Switch

PAIRING MONITOR TO CAMERA

Your WBU-800 should automatically pair with your monitor.

If your monitor does not automatically pair with the camera

after initial charge, the following steps are to be used.

NOTE: There are two ways to pair the camera, select the one

that works best for your situation.

1. Turn off the camera using the switch on the back of the

camera. If already mounted to vehicle skip step 1.

2. Power on monitor.

3. Press then or to place cursor over SETUP, then

press power to select.

4. With PAIR icon selected, press power to select process.

5. This system can support 2 cameras, select the camera you

would like to pair. Camera 1 is the rear camera, Camera 2

is the front camera.

6. Using switch on back of camera, turn camera back on.

If your camera is mounted to your vehicle, use the pairing

tool to press and release the pair button located above

the Micro USB charge port.

Pair OK will be displayed when the pairing process is

completed.

PAIR

Pair button