User's Guide

TEST THE CAMERA / PAIRING

Test the Camera

Prior to attaching the license plate to your vehicle, follow the

steps below to ensure pairing between the backup camera and

monitor.

1. Slide the switch on the rear housing of the camera to the On

position.

2. With power applied to the monitor, the top right button will

illuminate to indicate the monitor is ON.

3. The top right button will blink briefly to indicate that it

is attempting to communicate with the camera. When

connected to the camera, the top right button will turn solid.

It may take a moment for the camera to begin sending the

video information. Allow time for the image to be displayed.

4. If no image appears, see Troubleshooting section of this user

guide. The image will time out in 60 seconds (unless user has

selected a different time out option) however, if you wish to

shut the image off manually, press

anytime that video

is present to stop the video transmission and put the camera

back into the power conserve mode. (The top right button

will shut off when the timer expires)

5. The camera is equipped with 4 IR LEDs and a light sensor to

automatically illuminate during low light conditions. These IR

LED's are invisible to the human eye.

NOTE: If using a switched 12-volt DC Power port, it is not

necessary to power off the monitor.