User's Guide

MOUNTING THE MONITOR

Find a mounting surface inside the vehicle for the monitor

where it can be easily seen, and does not obstruct your vision

when driving.

NOTE: To maximize the effectiveness of the suction mount,

the mounting location surface temperature should be

between 50° and 100°F. Avoid application below 50°F.

NOTE: Before mounting the monitor, test the reception of

the camera signal in several selected locations within easy

reach as one may have better reception than another.

If mounting to the dashboard, the dash disk must be used to

ensure a smooth surface for the suction cup to attach.

1. Clean and dry the mounting surface before applying

suction cup or dash disk.

2. Press the suction mount against the mounting surface and

push the suction lock lever down. Make sure the mount is

attached securely.

3. Slide the monitor onto the monitor arm. The monitor angle

can be adjusted by loosening the monitor angle adjustment

knobs, tilting the monitor, then tightening the knobs.

4. Plug the monitor power cord into a 12-volt DC power port

inside the vehicle.

NOTE: See disclaimer section of this user guide.