User's Guide

ATTACH TO VEHICLE

Attach license plate to vehicle

Once you have tested the camera system and ensured the

pairing between the backup camera and monitor, you are

ready to reattach the license plate to your vehicle.

Use your OEM license plate mounting hardware when

mounting license plate to vehicle.

NOTE: Be sure to adjust the height of the camera assembly

to not impair readibility of the state, registration decal, stamp,

or other device indicating the month and year in which the

vehicles registration expires. Check local laws for compliance.

Adjust viewing angle

The camera angle should be adjusted to provide an optimal

view of objects behind the vehicle.

NOTE: Do not exceed 45 degrees down from central

position.

• Loosen the two screws below the camera a few turns.

(Do not remove.)

• To adjust the camera angle, tilt the camera to the correct

angle. (Do not force the camera)

• The camera should be adjusted to a horizontal position

relative to the ground, so as to provide optimal view of

objects behind the vehicle.

• Carefully tighten the 2 screws to prevent the camera

angle from moving during vibrations from driving.

Screws