User's Manual

6
Notice
Some states or local governments may have regulations or
laws that restrict the use of anything that might impair the
clear view of a license plate. Check local laws for compliance
These instructions are only meant as a general guide due to
the number of different makes and models of vehicles.
1. Remove license plate from vehicle and place on top of
the supplied license backplate.
2. Insert 2 short machine screws into 2 of the mounting holes
and finger tighten 2 machine nuts onto them in order to
hold the plates together for steps 3 thru 6.
3. Apply an adhesive strip to each of the solar panel bases
and two adhesive strips to the camera base as shown
below.
4. Peel the backing from the adhesive strips on the solar
panel bases and carefully slide onto each side (left and
right) of the plate assembly being careful not to make
contact with the adhesive until the base is fully inserted.
ASSEMBLY / INSTALLATION