User's Manual

Testing the System

1. With power applied to the monitor, the button backlight

will illuminate to indicate the monitor is ON and in

Standby mode.

2. The Blue LED will blink briefly to indicate that it is

attempting to communicate with the camera. When

connected to the camera, the blue LED will turn solid.

It may take a moment for the camera to begin sending

the video information, allow time for the image to be

displayed.

3. The Image is set to time out in 30 seconds however if

you wish to shut the image off manually, touch the multi-

function button anytime that video is present to stop

the video transmission and put the camera back into its

power conserve mode.

4. If 12-volt DC power port is live all the time, to shut the

button backlight off, touch and hold the

button for 3

seconds. The monitor retains this setting and must be

turned back on in order to receive video. This can be

done easily with a touch of the button. Standby is

confirmed when the button backlight remains ON.

NOTE: If Monitor has been shut off with

button, removing

the power source and reapplying will not turn your monitor on

as the OFF function is stored in Memory and the unit must be

turned ON with a touch of the

button.

NOTE: If using a switched 12-volt DC Power port, it is not

necessary to power off the monitor unless you do not wish

to receive an image automatically with the starting of your

vehicle.

OPERATION