Manual

Page 12

SC 062012

PREPARING THE UNIT FOR INSTALLATION

Applying Insulation Tape

Locate the (4) precut pieces of black foam tape included with the unit, two larger pieces

and two smaller pieces. To apply, simply peel back the white-paper adhesive covering

and place on the mounting bracket. The large pieces are applied to the top and bottom

while the smaller pieces are for the sides. This foam creates a tight seal between the

bracket and the wall.

Single Piece Mounting Bracket

The XLT Plus utilizes a single piece mounting bracket, this sturdy bracket frames the

installation location and secures the unit to the wall.

Mounting Bracket Installation

Select your desired bracket mounting location (see diagram below), this location deter-

mines the depth of the installation. For example, position #1 keeps most of the unit out of

the cellar while position #2 makes the back of the unit near ush on the exterior wall. Slide bracket onto unit, pay spe-

cial attention to the anges for mounting to the unit and that they are pointing towards the back. For the 2000i,3000i,

and 4000i Models: Use the (6) 1/2” self tappers to fasten the bracket to the unit. It is imperative not to use self tapping

screws longer than 1/2” in length. For the 6000i/8000i Models: Use the (6) 3/8” self tappers to fasten the bracket to the

unit. It is imperative not to use self tapping screws longer than 3/8” in length.

2000i/3000i/4000i

5-6” inches In Cellar

6000i/8000i

9.5-10.5” inches In Cellar

2000i/3000i/4000i

9-10” inches In Cellar

6000i/8000i

14-15” inches In Cellar

5” inch thick wall

(wall thickness may vary)

Mounting Bracket

Wine Cellar Exhaust Area