Troubleshooting guide

Page 22 PT-EXPL01 071609
LIQUID MEASURING THERMOSTAT SYSTEM
The WhisperKOOL Platinum Series cooling units come equipped with a liquid temperature measuring ther-
mostat system. This system incorporates the following advantages:
1. Self-Calibrating Probe: The probe contains a sensor chip, which actually communicates back and
forth to the thermostat. This results in a consistent temperature setting and accuracy. Do not remove
the tip from the probe!
2. Heavy-duty Circuitry: The circuitry within this new unit has been upgraded to resist power surges,
which play havoc on electrical components. This improvement will ensure years of trouble-free use.
However, for the highest reliability, we recommend that the customer install a surge protector for the
unit itself.
Measuring liquid temperature has a few unique advantages:
1. Wine temperature is kept in a very precise controlled environment. This assures a consistent tempera-
ture.
2. By measuring the liquid temperature rather than air, the unit will operate 75- 80% of the time.
To Use the thermostat:
1. Locate an empty wine bottle.
2. Fill 3/4 full with room temperature tap water.
3. Place bottle probe securely into bottle.
4. Place bottle with probe level and to the side
of the unit in your wine cellar. Avoid pulling
too much on the probe cord. It may become
disconnected resulting in non-operation of
the unit.
Note: The thermostat can be set between 50°F
and 76°F.
Remember: The WhisperKOOL System is based
on the temperature of the water.