Troubleshooting guide

Page 14 PT-EXPL01 071609
Foam Tape
Adhesive Covering
Mounting Flange Pieces
There are four individual pieces located in Kit 2 of your enclosed accessory kits. These  ange pieces are
designed to be used on the backside of the Extreme Platinum Series to mount to the exterior wall. There are
three punch-outs located on the exterior of the housing. The punch-outs are designed for speci c through-
the-wall installation mounts. Please refer to the illustration for location of the punch-outs.
#1. Retro t your current WhisperKOOL
cooling unit
#2. Middle wall installation
#3. Flush mount to exterior wall
THROUGH-THE-WALL INSTALLATION (without ductwork)
Applying Insulation Tape
Locate the four precut pieces of
black foam tape included with the
system. There should be two larger
pieces and two smaller pieces.
Once you have attached the  ange
pieces to the unit, peel back the
white-paper adhesive covering and
place on the corresponding size of
 ange. The large pieces are applied
to the top and bottom of the unit
and the smaller pieces to the right
and left side  anges. This foam cre-
ates a tight seal between the  ange
and the wall.
Front of unit
Back of unit