Technical information

TROUBLE SHOOTING

32 December 2010 / M-SC6/8/10 / EN

PROBLEM CAUSE SOLUTION

• Wear out of cylinder.

Have the compression measured and have the

engine overhauled.

Over-temperature

• Overload.

Take away the overload.

• Low level of cooling oil or air in the

cooling system

Fill up with liquid and release air bubbles.

Check if there are air blocks in the system;

refer to the installation manual

• Water inlet system blocked.

• Broken impeller.

• Water strainer choked

• Heat exchanger choked.

Check the cooling system thoroughly.

• Broken or slipping V-belt.

Replace and adjust the V-belt tension.

• Faulty thermostat

Check the thermostat or replace.

5.2.3 Warnings

Generator must be shut off immediately if:

● Motor RPM suddenly rises or drops.

● Unusual noise comes from generating set.

● Exhaust gases suddenly colour dark.

● Engine failure warning light is on

5.2.4 Service address

If you cannot correct a problem with the aid of the mal-

function table, contact your WhisperPower Service Centre

or WhisperPower Netherlands, tel: INT+31-512-571550.